To achieve
perfect results please read the instructions carefully BEFORE you
start.
They are really super easy to apply but this will enhance
your experience and give you the confidence you need to complete. Tatouage
is French for tattoo, so if it helps think of applying a tattoo to your wall
that can be removed...without all the mess and water.
Probably the most important thing to know especially
during the winter months is to let your Ezwordart transfer warm to room
temperature before application. I recommend taking it out of the box and
then lay it on a flat surface. Within a couple of hours the extreme
temperature changes your Ezwordart endured on the journey to you is okay.
When they are cold you will find getting the letters to release from the
backing a little harder.
There are three
components of your Ezwordart;
1. The first is the backing, which protects your word art
until you are ready to apply.
2. The second is the front masking which holds your quote in
place for transfer
3. The third are the words themselves.
You will hear me refer to these pieces in the application
process so familiarize yourself with them. All three components can be seen
in the second picture above.
Have the following tools
available;
Painters tape & Level
Many of you ask about using a wooden stick for application,
but unlike tatouage murals where you use a wooden stick to transfer the
image, Ezwordart is made of a pressure sensitive material so your finger
works best.
Application Process:
1. Position your quote and use the painters tape to lightly
secure to surface.
2. Use your level to make sure it is straight.
3. Leaving the painters tape on, lift the edge of the
transfer and slowly pull away the backing paper. As you do use the other
hand to smooth the transfer to surface. If you find a letter is not
releasing from the backing simply rub your finger over it and it will
release. Continue on until the backing is removed and only the front
masking and words are on the wall.
4. Use your finger to rub over the characters to ensure the
have adhered to surface.
5. Starting again in the corner slowly pull away the front
masking at an angle. If you find a characters edge is not releasing from the
front masking piece, again just rub over it with your finger. The friction
heat and pressure from your finger will cause it to release.
Congratulations! You're Done!
You have just changed the entire atmosphere of
your room! The transfer process is usually 10 minutes or less!
Tatouage Ezwordart - The #1 Choice of Professional
Interior Designers Everywhere!
